66
Default level
2: System level
Parameters
None
Description
Use the
link-aggregation load-sharing mode
local-first
command to enable local-first load sharing for
link aggregation.
Use the
undo link-aggregation load-sharing mode
local-first
command to disable local-first load sharing
for link aggregation.
By default, local-first load sharing is enabled for link aggregation.
Examples
# Disable local-first load sharing for link aggregation.
<Sysname> system-view
[Sysname] undo link-aggregation load-sharing mode local-first
link-aggregation port-priority
Syntax
link-aggregation
port-priority
port-priority
undo
link-aggregation
port-priority
View
Ethernet interface view
Default Level
2: System level
Parameters
port-priority
: Specifies a port aggregation priority, in the range 0 to 65535. The smaller this value, the
higher the port aggregation priority.
Description
Use the
link-aggregation
port-priority
command to set the aggregation priority of a port.
Use the
undo
link-aggregation
port-priority
command to restore the default setting.
The default aggregation priority of a port is 32768.
Examples
# Set the aggregation priority of port GigabitEthernet1/0/1 to 64.
<Sysname> system-view
[Sysname] interface gigabitethernet1/0/1
[Sysname-GigabitEthernet1/0/1] link-aggregation port-priority 64
