7
Figure 4 Rear mounting bracket and shoulder screw
(1) Hole for attaching the bracket to a rack
(2) Shoulder screw
Rack-mounting by using the front and rear mounting brackets
You can install the front mounting brackets at the port-side or power-side mounting position as
needed. The following takes power-side mounting as an example. The port-side mounting is similar.
This task requires two people.
To install the switch in a 19-inch rack by using the front and rear mounting brackets:
1.
Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
2.
Attach the front mounting brackets and shoulder screws to the chassis:
a.
Align the round holes in the wide flange of one front mounting bracket with the screw holes
in the power-side mounting position on one side of the chassis.
b.
Use M4 screws to attach the mounting bracket to the chassis.
c.
Repeat the proceeding two steps to attach the other mounting bracket to the chassis.
d.
Unpack the shoulder screws (provided). Attach the shoulder screw to one of the two
installation positions as red-marked in
e.
Repeat the proceeding step to attach the other shoulder screw to the chassis.
Figure 5 Attaching the front mounting brackets and shoulder screws to the chassis
