1-1
1
IP Routing Basics Configuration Commands
The term
router
in this document refers to both routers and Layer 3 switches.
IP Routing Basics Configuration Commands
display ip routing-table
Syntax
display ip routing-table
[
vpn-instance vpn-instance-name
] [
verbose
|
|
{
begin
|
exclude
|
include
}
regular-expression
]
View
Any view
Default Level
1: Monitor level
Parameters
vpn-instance vpn-instance-name
: Displays routing table information for a VPN instance. The
vpn-instance-name
is a string of 1 to 31 case-sensitive characters.
verbose
: Displays detailed routing table information, including inactive routes. With this keyword
absent, the command displays only brief information about active routes.
|
: Uses a regular expression to filter output information. For details about regular expressions, see
CLI Configuration
in the
Basic Configuration Guide
.
begin
: Displays route entries starting from the one specified by the regular expression.
exclude
: Displays route entries not matching the regular expression.
include
: Displays route entries matching the regular expression.
regular-expression
: Regular expression, a string of 1 to 256 case-sensitive characters used for
specifying routing entries.
Description
Use the
display ip routing-table
command to display brief information about active routes in the
routing table.
This command displays brief information about the routing table, with a routing entry contained in
one line. The information displayed includes destination IP address/mask length, protocol, priority,
cost, next hop and outbound interface. This command only displays the optimal routes.
