9-18
display ospfv3 peer statistic
Syntax
display ospfv3 peer statistic
View
Any view
Default Level
1: Monitor level
Parameters
None
Description
Use the
display ospfv3 peer statistic
command to display information about all OSPFv3 neighbors
on the router, that is, numbers of neighbors in different states.
Examples
# Display information about all OSPFv3 neighbors.
<Sysname> display ospfv3 peer statistic
OSPFv3 Router with ID (1.1.1.1) (Process 1)
Neighbor Statistics
----------------------------------------------------------------------
Area ID Down Init 2-way ExStar Exchange Loading Full
0.0.0.0 0 0 0 0 0 0 1
Total 0 0 0 0 0 0 1
Table 9-12 display ospfv3 peer statistic
command output description
Field
Description
Area ID
Area ID
Down
In this state, neighbor initial state, the router has not received any information from a
neighboring router for a period of time.
Init
In this state, the device received a Hello packet from the neighbor but the packet
contains no Router ID of the neighbor. Mutual communication is not setup.
2-Way
Indicates mutual communication between the router and its neighbor is available.
DR/BDR election is finished under this state (or higher).
ExStart
In this state, the router decides on the initial DD sequence number and master/slave
relationship of the two parties.
Exchange
In this state, the router exchanges DD packets with the neighbor.
Loading
In this state, the router sends LSRs to request the neighbor for needed LSAs.
Full
Indicates LSDB synchronization has been accomplished between neighbors.
