38
(1) Ejector lever
(2) Latch
4.
Press the latch on the expansion module to release the ejector lever.
5.
Insert the expansion module slowly into the slot along the guide rails, as shown by callout 1 in
6.
Rotate inward the ejector lever as shown by callout 2 in
ejector lever in place.
Figure2-56 Installing an LSWM18QC interface module
Removing an expansion module
CAUTION:
•
Before you remove an expansion module, remove the cable from it to avoid cable damage.
•
If you are not to install a new expansion module after removing the original one, install the filler
panel in the slot to prevent dust and ensure good ventilation in the device.
To remove an expansion module:
1.
Prepare an anti-static bag.
2.
Wear an ESD wrist strap and make sure the wrist strap makes good skin contact and is reliably
grounded.
3.
Press the latch to release the ejector lever
4.
Rotate outward the ejector lever as shown by callout 1 in
5.
Pull out the expansion module slowly out of the expansion slot, as shown by callout 2 in
6.
Place the removed expansion module in the anti-static bag.
Figure2-57 Removing an LSWM18QC interface module
2
1
1
2
