31
Figure2-43 Removing an LSVM1AC300 power module
(1) Pivot the latch to the right with your thumb
(2) Pull the power module out
Removing an LSVM1DC300/LSVM1DC650/PSR450-12D power module
1.
Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
2.
Remove the power cord from the power module.
For an LSVM1DC300 or LSVM1DC650 power module, squeeze the tabs on the power cord
connector with your thumb and forefinger, and pull the connector out of the power module.
See
For a PSR450-12D power module, use a flat-head screwdriver to loosen the screws on the
power cord connector, and then pull the connector out of the power module. See
3.
Hold the handle on the power module with one hand, pivot the latch on the power module to the
right with your thumb, and pull the power module part way out of the slot, as shown in
4.
Supporting the power module bottom with one hand, slowly pull the power module out with the
other hand.
5.
Put the removed power module in an antistatic bag for future use.
2
1
