25
Figure 34 Completing the device driver installation wizard
Setting terminal parameters
To configure and manage the switch through the console port, you must run a terminal emulator
program, TeraTermPro or PuTTY, on your configuration terminal. You can use the emulator program
to connect a network device, a Telnet site, or an SSH site. For more information about the terminal
emulator programs, see the user guides for these programs
The following are the required terminal settings:
•
Bits per second
—9600.
•
Data
bits
—8.
•
Stop
bits
—1.
•
Parity
—None.
•
Flow
control
—None.
Starting the switch
1.
Before powering on the switch, verify that the following conditions are met:
{
All the fan tray slots have a fan tray installed.
{
The power cords are connected correctly.
{
The input power voltage is as required by the switch.
{
The console cable is connected correctly.
{
The configuration terminal (a PC, for example) has started, and its serial port settings are
consistent with the console port settings on the switch.
