Command Manual – PoE
H3C S7500 Series Ethernet Switches
Chapter 1 PoE Configuration Commands
1-1
Chapter 1 PoE Configuration Commands
1.1 PoE Configuration Commands
1.1.1 display poe interface
Syntax
display poe interface
{
interface-type interface-number
|
all
}
View
Any view
Parameters
interface-type interface-number
: Port on the switch. Refer to
Command Manual – Basic
Port Configuration
for details.
all
: Displays the PoE information of all the PoE ports on the switch.
Description
Use the
display poe interface
command to view the PoE status of a specific port. If the
all
keyword is specified, the command displays the PoE status of all the PoE ports.
Examples
# Display the PoE status of Ethernet 3/0/1.
<H3C> display poe interface Ethernet 3/0/1
Port power status :PD searching
Port power mode :signal
Port PD class :0
port power priority :low
Port max power :15400 mW
Port current power :0 mW
Port average power :0 mW
Port peak power :0 mW
Port current :0 mA
Port voltage :0.0 V
