10
Figure 9
Installing an SFP module
NOTE:
•
Do not remove the dust plug of the SFP module port before installing an optical fiber.
•
For an SFP+ module installed with an optical fiber, remove the fiber before you install the SFP module
into the slot.
Connection procedure
To connect an optical fiber:
1.
Put on an ESD-preventive wrist strap, and make sure it makes good skin contact, and is well
grounded.
2.
Remove the protective cap from the fiber connector, and use dust free paper and absolute alcohol
to clean the end face of the fiber connector.
3.
Connect one end of the fiber to the SFP module of the S9500E switch.
4.
Connect the other end of the fiber to the peer device.
Figure 10
Connecting an optical fiber to an SFP module
Connecting an SFP+ cable (optional)
When connecting SFP+ ports located near each other, besides SFP+ transceiver module and optical
fiber, you can use an SFP+ cable.
LC plug
SFP module
Summary of Contents for S9500E Series
Page 13: ...12 Figure 12 Installing FMTs...
