Installation Manual
H3C SecPath F1000-E Firewall
Chapter 4 Installing the Firewall
4-6
(1)
(2)
(3)
(5)
(4)
(1) Grounding screw
(2) OT terminal
(3) Grounding screw hole
(4) Grounding sign
(5) PGND cable
Figure 4-7
Connect the grounding terminal of the PGND cable to the firewall
Follow these steps to connect the PGND cable:
1) Remove the grounding screw from the firewall chassis.
2) Put the supplied OT terminal of the PGND cable on the grounding screw.
3) Fasten the grounding screw, which is attached with the OT terminal of the PGND
cable, into the grounding screw hole with a screwdriver.
4) Connect the other end of the PGND cable to the ground. Generally, the cabinets
installed in equipment rooms are equipped with a grounding bar.
z
If a grounding bar is available, you can connect the PGND cable of the firewall to
the grounding bar as follows: a) Use a cable stripper to strip off the insulation
rubber about 15 mm (0.59 in.) from the PGND cable. b) Wrap the naked part onto
the grounding post of the grounding bar. c) Fix the PGND cable onto the grounding
post with a hex nut.
z
If no grounding bar is available, connect the naked part of the PGND cable to the
ground directly.
