Installation Manual
H3C SecPath F1000-E Firewall
Chapter 4 Installing the Firewall
4-15
Figure 4-15
Connect the RPS DC power cable
7) Connect the other end of the RPS cable to the RPS power output port.
(1)
(2)
(3)
(6)
(5)
(4)
(1) RPS
(2) RPS power output port
(3) Connector of the RPS power output port
(4) RPS power cable
(5)Connector for the RPS power socket on the firewall
(6) RPS power socket
Figure 4-16
Connect the RPS DC power cable to the RPS power output port
8) Turn on the power switch on the firewall and the RPS power switch.
9) Check the status of the OK LED on the RPS front panel. If it is on, the RPS power
works normally.
4.10 Connecting Port Cables
4.10.1 Connecting the Console Cable
Follow these steps to connect the console cable:
1) Select a configuration terminal.
The configuration terminal can be a standard ASCII terminal with an RS232 serial port,
or a common PC.
