Installation Manual
H3C SecPath F1000-E Firewall
Chapter 7 Maintaining Hardware
7-8
1) Make sure that the CF card LED is not flashing before proceeding with the next
step.
2)
Press the CF card eject button in and make sure it does not project from the panel.
3)
Insert the CF card into the slot and push it all the way in until it is firmly seated.
Figure 7-10
Insert the CF card into the slot
Note:
If the application program for booting the firewall is stored in an external CF card, make
sure that the right CF card has been correctly installed in the slot; otherwise the firewall
will fail to start.
7.7.2 Removing a CF Card
Follow these steps to remove a CF card:
1) Make sure that the CF card LED is not flashing before proceeding with the next
step.
2)
Press the eject button so that it projects from the panel.
Figure 7-11
Press the eject button
