Installation Manual
H3C SecPath F1000-E Firewall
Chapter 4 Installing the Firewall
4-21
z
Check the status of the LED of the corresponding interface module slot on the
front panel: If the LED is on, the power-on self test (POST) succeeds and the
module works normally; if the LED is off, POST fails and you need to contact the
sales agent.
z
For a 4GBE/8GBE interface module, check the status of the LED on the module
panel. For the status of the LED, see Table 2-1 in Chapter 2 “Interface Modules”.
4.11 Verifying Installation
Each time you power on the firewall during installation, you must verify that:
z
There is enough space around the firewall for heat-dissipation and the workbench
is stable enough.
z
The power source meets the requirements of the firewall.
z
The PGND cable of the firewall is correctly connected.
z
The firewall is correctly connected to the configuration terminal and other devices.
Caution:
It is very important to verify the installation because the firm installation, good
grounding and correct power input directly affect the operation of the firewall.
