Installation Manual
H3C SecPath F1000-E Firewall
Chapter 5 Starting and Configuring the Firewall
5-1
Chapter 5 Starting and Configuring the Firewall
You can use only the console port to make initial configuration of the F1000-E.
5.1 Setting Up a Configuration Environment
5.1.1 Connecting the Firewall to a Configuration Terminal
For how to connect the firewall to the configuration terminal, refer to section 4.10.1
“Connecting the Console Cable” in Chapter 4 “Installing the Firewall“.
5.1.2 Setting the Parameters for the Console Terminal
1) Create a connection. Select
Start
>
Programs
>
Accessories
>
Communications
>
HyperTerminal
, and enter a connection name in the
Connection Description
dialog box, as shown below.
Figure 5-1
Create a connection
2)
Select a connection port. Select a serial port from the
Connect using
drop-down
list in the
Connect to
dialog box, as shown below. Be sure to select the serial port
to which the console cable is actually connected.
