4-32
Figure4-3 Removing an interface module
Replacing a drive
CAUTION:
•
To avoid storage medium damage, execute the
umount
command from the CLI to unmount all
partitions before removing a drive.
•
Do not hot swap drives.
To replace a drive:
1.
Log in to the Web interface. Click the
Unmount
button on the
Storage settings
page.
2.
Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
3.
Press the button at the right side of the drive panel to release the locking lever.
4.
Hold the locking lever and pull the drive out of the slot.
5.
Install a new drive. For the installation procedure, see "
Figure4-4 Removing a drive
Replacing a transceiver module
WARNING!
Disconnected optical fibers or transceiver modules might emit invisible laser light. Do not stare into
beams or view directly with optical instruments when the firewall is operating.
When you replace a transceiver module, make sure the two transceiver modules connected by the
same optical fiber are the same type. Do not touch the golden plating of the transceiver module.
2
2
1
3
1
1
2
3
