2
Configuration procedure
Step
Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter interface range
view.
•
interface range
{
interface-type
interface-number
[
to
interface-type
interface-number
] } &<1-5>
•
interface range
name
name
[
interface
{ int
erface-type
interface-number
[
to
interface-type
interface-number
] } &<1-5> ]
By using the
interface range
name
command, you assign a name to an
interface range and can specify this
name rather than the interface range to
enter the interface range view.
3.
(Optional.) Display
commands available for
the first interface in the
interface range.
Enter a question mark (?) at the
interface range prompt.
N/A
4.
Use available
commands to configure
the interfaces.
Available commands depend on the
interface.
N/A
5.
(Optional.) Verify the
configuration.
display this
N/A
Displaying and maintaining bulk interface
configuration
Execute the
display
command in any view.
Task Command
Display information about the interface ranges
created by using the
interface range name
command.
display interface range
[
name
name
]
