16
3.
Open the ejector levers on the module and slide the module steadily into the slot along the
guide rails.
4.
Close the ejector levers until they touch the panel tightly and the module seats into the
backplane.
5.
Fasten the captive screws on the module with a Phillips screwdriver.
Figure2-9 Installing an interface module
Installing a hard disk
CAUTION:
•
Hard disks are not hot swappable.
•
Hold a hard disk by its sides. Do not touch hard disk components and do not squeeze, vibrate, or
strike the hard disk.
•
Install a filler panel over empty hard disk slots to avoid damage caused by build-up dust.
•
Before using a hard disk, execute the
fdisk
and
format
commands from the CLI to partition
and format the hard disk.
The device does not come with any hard disks and cannot recognize hard disks from other vendors.
Purchase hard disks from H3C as needed.
To install a hard disk:
1.
Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
2.
Remove the filler panel over the hard disk slot.
3.
Press the red button on the hard disk panel to release the locking lever.
4.
Hold the locking lever, slide the hard disk into the slot along the guide rails, and then close the
locking lever.
1
2
5
3
4
4
5
