7
NS-HTIM-GMG2B
Table 9 Compatible hardware and software for the NS-HTIM-GMG2B encryption module
Compatible firewalls
Compatible slots
Software version
•
F5030-D, F5060-D, F5080-D
•
F5000-AK515, F5000-AK525
Slots 2/1
E9620 or higher
Installing the encryption modules
No encryption modules are provided with the device. Purchase them as needed.
Installing an NSQM1F1KGM0 encryption module
An NSQM1F1KGM0 encryption module is 1U high and occupies two interface module slots.
To install an NSQM1F1KGM0 encryption module:
1.
Face the rear panel of the device and identify the target slots.
2.
Use a Phillips screwdriver to loosen the captive screws on the filler panels and then remove the
filler panels from the slots.
Keep the removed filler panels secure.
Figure 8 Removing the filler panels
3.
Open the ejector levers of the encryption module and then gently push the module into the slots
along the guide rails.
4.
Close the ejector levers. Make sure the module is seated securely in the slots.
5.
Use a Phillips screwdriver to fasten the captive screws on the module.
1
2
