Installation Manual
H3C SecPath V100-S Security Gateway
Chapter 4 Booting and Configuring the SecPath V100-S
4-2
Figure 4-2
Setting up a new connection
Step 3: Enter the name of the new connection in the [Name] field and click <OK>. The
dialog box as shown in Figure 4-3 pops up.
Step 4: Select the serial port to be used from the Connect Using drop-down list. The
serial port selected here must be the one connected to the console cable.
Figure 4-3
Setting the connection port
Step 5: Click <OK>. The [Settings] tab appears as shown in Figure 4-4, and you can set
the serial port parameters. Set the following parameters:
z
Bits per second = 9600
z
Data bits = 8
z
Parity = none
