Installation Manual
H3C SecPath V100-S Security Gateway
Chapter 5 Software Maintenance
5-10
PC
WAN
H3C SecPath V100-S (FTP Server)
Ethernet interface
10.110.10.10/24
(FTP Client)
10.110.10.13/24
Router
Figure 5-4
Setting up the local upload/download environment
Step 1: Connect the PC through WAN to any interface of the security gateway. The IP
addresses of the PC and the security gateway can be in different network segments.
Step 2: Copy the application, Boot ROM program or configuration files to a specific path.
Here suppose the path is C:\ version.
II. Booting FTP server
Ask for the cooperation of the service personnel at the security gateway side and
perform the following configuration:
Step 1: Configure authentication mode.
Note:
You can perform AAA authentication configuration as needed. See the AAA and
RADIUS configuration part in
H3C SecPath
Series Security Products Operation
Manual
for details.
Step 2: Add a user name and the password.
[SecPath] local-user SecPathGateway password simple 123
SecPathGateway represents the user name, and 123 represents the password.
Step 3: Add service type.
[SecPath] local-user NATGateway service-type ftp
Step 4: Add the authority level.
[SecPath] local-user NATGateway level 3
Step 5: Specify FTP directory.
[SecPath] local-user NATGateway ftp-directory flash
Step 6: Boot FTP server.
[SecPath] ftp-server enable