27
Status Description
Flashing green
Data is being transmitted or received at 1000 Mbps.
Steady yellow
A 100 Mbps link is present.
Flashing yellow
Data is being transmitted or received at 100 Mbps.
Interface specifications
Table 28
SFP port specifications
Item Specification
Connector type
SFP
Number of interfaces
8
Interface standards
802.3, 802.3u, 802.3ab
Frame format
•
Ethernet_II
•
Ethernet_SNAP
Optical
transmit
power
Type
Short
distance
Medium
distance
Long distance
Long
distance
Ultra-long
distance
Min.
–9.5 dBm
–9 dBm
-–2 dBm
–4 dBm
–4 dBm
Max.
0 dBm
–3 dBm
5 dBm
1 dBm
2 dBm
Receiving sensitivity
–17 dBm
–20 dBm
–23 dBm
–21 dBm
–22 dBm
Central wavelength
850 nm
1310 nm
1310 nm
1550 nm
1550 nm
Max. transmission distance
0.55 km
(0.34 miles)
10 km (6.21
miles)
40 km
(24.86 miles)
40 km
(24.86
miles)
70 km (43.50
miles)
Fiber type
62.5/125
μ
m
multi-mode
9/125
μ
m
single-mode
9/125
μ
m
single-mode
9/125
μ
m
single-mod
e
9/125
μ
m
single-mode
Transmission rate
•
100/1000 Mbps, half/full duplex
The following transceiver modules are available for the HIM-8GBP-V2:
•
100 Mbps fiber SFP transceiver modules.
•
1000 Mbps fiber SFP transceiver modules.
•
100/1000 Mbps fiber SFP transceiver modules.
•
10/100/1000 Mbps copper SFP transceiver modules (support for 10/100/1000 Mbps
autosensing on the HIM-8GBP-V2).
Prepare the transceiver modules yourself as required.
H3C recommends that you use H3C SFP transceiver modules for the device. H3C does not guarantee the
compatibility of SFP transceiver modules from other vendors with the device. The device reports an alarm
when non-H3C SFP transceiver modules are installed.
Interface cables
Use interface cables for the HIM-8GBP-V2 as follows:
•
Fiber SFP transceiver module
—Fibers with the LC connector.
