3-41
Figure 3-10
Configuration page
Configuring Password Authentication for Telnet Login
Configuration prerequisites
You have logged in to the device.
By default, you can log in to the device through the console port without authentication and have user
privilege level 3 after login. For how to log in to the device with default configuration, see
.
Configuration procedure
Follow these steps to configure password authentication for telnet login:
To do…
Use the command…
Remarks
Enters system view
system-view
—
Enable telnet
telnet server enable
Required
By default, the telnet service is
enabled.
Enter one or multiple VTY user
interface views
user-interface vty
first
-
number
[
last-number
]
—
Specify the password
authentication mode
authentication-mode password
Required
By default, authentication mode
for VTY user interfaces is
password
.
Set the local password
set authentication password
{
cipher
|
simple
}
password
Required
By default, no local password is
set.
Configure the user privilege level
for login users
user privilege level
level
Required
0 by default.
Configure common settings for
VTY user interfaces
—
Optional
See
Settings for VTY User Interfaces
(Optional)
.
Summary of Contents for SR6600 SPE-FWM
Page 112: ...6 101...
