10-10
7.
Remove the support bracket from the GPU.
Figure10-14 Removing the GPU support bracket
8.
Put the removed GPU bracket on an antistatic mat.
9.
Install a new GPU in the PCIe slot on the riser module. For the installation procedure, see
"
If you are not to install a new GPU, install a module blank in the PCIe slot and then reinstall the
access panel.
Replacing an M.2 SSD
1.
Power off the device.
2.
Remove the access panel. For more information, see "
Replacing a storage controller
3.
Use a Phillips screwdriver to remove the screw that secures the M.2 SSD on the chassis.
4.
Pull the SSD out of the connector and keep the SSD secure for future use.
Figure10-15 Removing an M.2 SSD drive
