13
Figure 17 Logical Device Configuration screen
3.
On the screen as shown in
, select the drives to be configured as a RAID array.
(
[Enabled]
following a drive means that the drive has been selected.) Then, select
PROCEED
and press
Enter
.
A raw drive cannot be selected. To configure a RAID array for the drive, you must first initialize
the drive. For more information about initializing drives, see "
."
Figure 18 Selecting drives
4.
On the screen as shown in
, select
Array type
to set a RAID level, select
PROCEED
,
and press
Enter
.
Summary of Contents for UniServer B5700 G3
