10
Figure 16 Selecting physical disk operations
4.
On the screen as shown in
, select
Select Physical Disk
. On the pop-up window that
opens, select the physical drive you want to locate and press
Enter
.
Figure 17 Selecting a physical drive
5.
Select
Start Locate/Blink
and press
Enter
.
6.
On the server, identify the physical drive of which the Fault/UID LED is steady blue.
Configuring controller settings in legacy mode
This section describes how to configure the storage controller settings in legacy mode. For more
information about how to enter the BIOS and set the boot mode to legacy, see the BIOS user guide
for the server.
Summary of Contents for UniServer B5700 G3
