5
Figure 3 Storage controller configuration screen
Switching the operating mode
If RAID arrays have been created, delete all the RAID arrays before you switch the mode.
To switch the operating mode:
1.
On the storage controller configuration screen as shown in
, select
Configure
Controller Settings
and press
Enter
.
Figure 4 Storage controller configuration screen
2.
On the screen as shown in
, select
Modify Controller Settings
or
Configure
Controller Port Mode
, and press
Enter
.
This section uses
Modify Controller Settings
as an example.
Summary of Contents for UniServer E3200 G3
