11-38
TEMP LED
LED status
Error code
Description
Flashing red
Temperature
sensor ID
A severe temperature warning is present on the
component monitored by the sensor.
This warning might occur because the temperature of the
component has exceeded the upper threshold or dropped
below the lower threshold.
CAP LED
LED status
Error code
Description
Flashing amber
01
The system power consumption has exceeded the power cap value.
Component LEDs
An alarm is present if a component LED has one of the following behaviors:
•
Flashing amber (0.5 Hz)
—A predictive alarm has occurred.
•
Flashing amber (1 Hz)
—A general alarm has occurred.
•
Flashing red (1 Hz)
—A severe alarm has occurred.
Use
to identify the faulty item if a component LED has one of those behaviors. To obtain
records of component status changes, use the event log in HDM. For information about using the
event log, see HDM online help.
Table 11-12 LED, error code and faulty item matrix
LED
Error code
Faulty item
BRD
11 System
board
21, 22, or 23
Front drive backplane
32
Rear 2SFF drive backplane
71
Mezzanine storage controller power
81 Reserved
91
mLOM Ethernet adapter
NOTE:
If the error code field displays 11 and any other code alternatively, replace the faulty item
other than the system board. If the issue persists, replace the system board.
CPU
(processor)
01 Processor
1
02 Processor
2
DIMM
A1 through A8
DIMMs in slots A1 through A9
b1 through b8
DIMMs in slots B1 through B9
HDD
00 through 03
Relevant front drive (4LFF server)
00 through 07
Relevant front drive (8SFF server)
00 through 09
Relevant front drive (10SFF server)
00 or 01
Relevant rear drive
PCIE
01 or 02
PCIe modules in PCIe slot 1 or 2 of the riser card
