76
Figure 84 Removing a PCIe module from the riser card
Installing a riser card and a PCIe module
1.
Install a PCIe module on the riser card:
a.
Insert the PCIe module into the slot on the riser card along the guide rails. Snap the module
tail to insert the standout on the riser card into the blank notch in the tail to secure the
module, as shown by callout 1 in
..
b.
Close the retaining latch on the riser card, as shown by callout 2 in
Figure 85 Installing a PCIe module onto the riser card
2.
Install the riser card on the server:
a.
Remove the riser card blank. For more information, see "
Removing the riser card blank over
Removing the riser card blank over PCIe riser connector 3
b.
Install the riser card on the PCIe riser connector, with the two standouts on the card aligned
with the notches in the chassis, as shown in
