3
WA2110-AG quick start guide
This guide provides steps for basic hardware installation for the WA2110-AG access point.
Further information, such as optional installation and configuration procedures and
technical specifications about connections and power are available in the
H3C
WA2110-AG WLAN Access Point Installation Guide
.
The WA2110-AG is a managed wireless LAN access point designed for use with an H3C
WX series access controller/unified switch and requires only hardware installation. All
configurations for the access point take place on the access controller/unified switch.
Prepare for installation
H3C recommends that all installation and removal of the unit and its accessories be
carried out by qualified personnel. Read all of the safety and installation instructions
supplied with your device before installation and operation.
Unpacking and inspection
Before unpacking the AP, ensure that the package is not damaged and that it does not
show signs of water damage. When unpacking the contents, avoid excessive force.
The accessories vary with the models. For the exact contents of the package, refer to
the packing list. If the contents do not match the packing list, contact your H3C
representative.
If the package is found to be rusted or water soaked, stop unpacking and contact your
H3C representative immediately.
Installation tools
Collect the following tools before installation:
Mounting bracket and screws that come with the device
Electric screwdriver and Phillips screwdriver
One electric drill and 6 mm (0.24) drill bit
