Installation Manual
H3C WA2200 Series WLAN Access Points
Chapter 4 Installation of Outdoor APs
4-3
Figure 4-3
Wall-mounting bracket structure and positions of screw holes
2) Drill
holes
Step
Operation
1
Use a percussion drill with a 6-mm (0.24-in) bit to drill holes on the three
markings.
Observe the following precautions when drilling:
z
Hold the drill handle with both hands, with the bit perpendicular to the wall surface,
and prevent wall damage or tilted holes.
z
The hole depth should be the anchor length plus the bit length. Each hole should
have the same depth. Remove the dust from the hole before measuring the hole
depth. Use a vacuum cleaner to prevent dust from spreading around.
z
If the wall surface is too solid and slippery to locate the bit, punch a notch first.
3) Install
anchors
