Installation Manual
H3C WA2200 Series WLAN Access Points
Chapter 5 Software Setting
5-8
IV. Binding the configurations to AP view
Follow these steps to bind the configurations to AP view:
Step
Operation
1
Enter system view.
<H3C>system-view
System View: return to User View with Ctrl+Z.
[H3C]
2
Enter AP view and then radio view.
For example, enter AP view named aptest2 and then radio 1 view.
[H3C]wlan ap aptest2
[H3C-wlan-ap-aptest2]radio 1
[H3C-wlan-ap-aptest2-radio-1]
3
Bind a radio policy and a service template to an RF interface in AP view.
For example, bind radio-policy 1 and service template 101 to the first RF
interface in AP view named aptest2.
[H3C-wlan-ap-aptest2-radio-1]radio-policy 1
[H3C-wlan-ap-aptest2-radio-1]service-template 101
[H3C-wlan-ap-aptest2-radio-1]
After the above configurations, wireless stations can detect and access the network
whose SSID is fytest1.
5.3.3 Security Setting
For the purpose of security, an encryption method can be applied to the authentication
of wireless stations and communication between wireless stations and the FIT AP. The
following describes how to set the WEP104 encryption method on the AC.
I. Setting the encryption template
Follow these steps to set the encryption template:
Step
Operation
1
Enter system view.
<H3C>system-view
System View: return to User View with Ctrl+Z.
[H3C]
2
Create a service template, for example, encryption template 22, and enter
its view.
[H3C]wlan service-template 22 crypto
[H3C-wlan-st-22]
