7
Connecting the power supply
Local power supply
Connect the AP to the power source through the power adapter.
Power over Ethernet (PoE)
If the uplink device of the AP is a PoE-capable switch, use an Ethernet cable to connect
the Ethernet interface of the AP to the PoE-capable device.
CAUTION:
In the PoE mode, you do not need to connect the power interface to a power source. You
only need to connect one end of an Ethernet cable to the Ethernet interface of the AP and
the other end to an Ethernet interface of the PoE-capable device (for example, an Ethernet
switch).
Identify the silkscreen on the device to avoid confusing the console interface for the Ethernet
interface and vice versa.
The WA2620E-AGN supports only non-standard PoE power supply (the PoE input power must
be at least 16W).
Connecting the AP to the network
The WA2600 enhanced series can access the Internet or metropolitan area network
(MAN) through the Ethernet uplink interface. Connect the Ethernet interface of the AP
to an Ethernet interface of an Ethernet switch to implement Internet or MAN access.
For details on configuring your AP (work in fat mode), see the
H3C WA Series WLAN
Access Points Configuration Guides
,
H3C WA Series WLAN Access Points Command
References
, and
H3C WA Series WLAN Access Points Web-Based User Guides
on our
website:
http://www.h3c.com
