7
CAUTION:
Connect the AP to the network by using an Ethernet cable, and then install the AP to the wall-mounting
bracket when you mount the AP on a wall.
To mount the AP on a wall:
1.
Fix the wall-mounting bracket to the wall:
a.
Use the wall-mounting bracket as a template to mark the locations of the mounting holes on the
bracket. Drill three 5 mm (0.2 in) diameter holes at the mounting hole locations you marked.
b.
Insert a wall anchor into each mounting hole, and tap the wall anchor with a rubber hammer
until it is all flush with the wall surface.
c.
Align the holes in the wall-mounting bracket with the anchors and insert screws through the
installation holes into the wall anchors.
d.
Adjust the position of the wall-mounting bracket and tighten the screws.
Figure 5
Install the wall-mounting bracket
(1) Wall anchor
(2) Wall-mounting bracket
(3) Hook
(4) Clip
(5) Screw
2.
Connect the AP to the network by using an Ethernet cable.
3.
Align the mounting keyhole on the rear of the AP over the hook on the wall-mounting bracket.
See
Figure 6
.
Summary of Contents for WA3610i-GN
Page 7: ......
Page 29: ...Compliance and Safety Manual...
