9
Mounting the AP on a wall or ceiling (II)
NOTE:
•
The wall or ceiling tiles must be less than 18 mm (0.71 in) thick, and the wall or the ceiling can bear a
weight of at least 5 kg (11.02 lb).
•
Do not use this method to mount the AP to a location made of low-intensity materials such as a plaster
ceiling. If this installation method is required in such an environment, put a high-intensity plate beneath
the ceiling to secure the installation.
The two bolt holes shown in
Figure 8
are needed for mounting the AP on a wall.
Figure 8
Bolt holes on the wall-mounting bracket (in mm)
(1) Bolt hole 1
(2) Bolt hole 2
To install the AP on a wall:
1.
Drill two 6.2 mm (0.24 in) diameter holes in the wall or ceiling where you want to mount the AP.
The distance between the two holes must be the same as the distance between the two bolt holes
on the mounting bracket.
2.
Insert the hex-head bolts into the bolt holes on the mounting bracket and the holes in the wall or
ceiling. From the other side of the wall or from above the ceiling, fasten the hex nuts to the
hex-head bolts to fix the mounting bracket to the wall or ceiling.
3.
Connect the AP to the network by using an Ethernet cable.
4.
Fix the AP to the mounting bracket. For more information, see “
Mounting the AP on a wall (I)
.”
Summary of Contents for WA3610i-GN
Page 7: ......
Page 29: ...Compliance and Safety Manual...
