H3C WA4320H-ACN, Safety Manual

8 

radar system in the area. The presence of nearby radar operation may result in temporary 
interruption in communications of this device. The Access Point’s radar detection feature will 
automatically restart operation on a channel free of radar. You may consult with the local 
technical support staff responsible for the wireless network to ensure the Access Point device(s) 
are properly configured for European Community operation. 

Table 4 Europe-Restrictions for Use of 5GHz Frequencies in European Community Countries 

Allowed Frequency Bands  Allowed Channel Numbers

Countries 

5.15-5.35&  
5.470-5.725GHz 

36,40,44,48,52,56,60,64,100,10
4,108,112,116,132,136,140 
38,46,54,62, 102,110,134 

Austria, Belgium, Bulgaria, Cyprus, 
Croatia, Czech Republic, Denmark, 
Estonia, Finland, France, Germany, 
Greece, Hungary, Iceland, Ireland, 
Italy, Latvia, Liechtenstein, Lithuania, 
Luxembourg, Malta, Netherlands, 
Norway, Poland, Portugal, Romania, 
Slovakia, Slovenia, Spain, Sweden, 
Switzerland, U.K. 

USA regulatory compliance 

FCC Part 15

US Federal Communications Commission (FCC) EMC Compliance 

This product has been tested and found to comply with the limits for a Class B digital device, 
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection 
against harmful interference in a residential installation. This equipment generates, uses and can 
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may 
cause harmful interference to radio communications. However, there is no guarantee that 
interference will not  occur in a particular installation. If this equipment does cause harmful 
interference to radio or television reception, which can  be determined by turning the equipment off 
and on, the user is encouraged to try to correct the interference by one or more of the following 
measures: 

•

Reorient or relocate the receiving antenna. 

•

Increase the separation between the equipment and receiver. 

•

Connect the equipment into an outlet on a circuit different from that to which the receiver is 
connected. 

•

Consult the dealer or an experienced radio/ TV technician for help. 

This product complies with Part 15 of the FCC Rules. Operation is subject to the following two 
conditions: 

1. 

This device may not cause harmful interference.  

2. 

This device must accept any interference received, including interference that may cause 
undesired operation. 

If the customer modifies the equipment without the authorization of H3C, which directly or indirectly 
contribute to the equipment incompliance with FCC requirements for Class B digital devices, H3C is 
not liable for such interference problem and the expenses incurred there from shall be covered by 
the customers.