3
Warning:
When installing the product on the wall you must choose a suitable fixing.
Achtung:
Wenn Sie das Produkt an der Wand anbringen, müssen Sie eine passende
Befestigungslösung wählen.
警告：将设备安装到墙上时，必须选取合适的固定方式。
Warning:
When mounting the product on a wall, do not mount it with ventilation holes facing up
or down.
Warnung:
Wenn das Produkt an einer Wand montiert wird, installieren Sie ihn nicht mit den
Lüftungsöffnungen nach oben oder unten gerichtet.
警告：将设备安装到墙上时，请勿将散热孔朝上或朝下。
Warning:
When making connections, be careful not to push the product up and off the wall.
Warnung:
Achten Sie darauf, das Produkt nicht nach oben und von der Wand zu schieben,
wenn Sie die Anschlüsse vornehmen.
警告：进行连接时，请不要向上推动设备，以免设备从墙上掉落。
Warning Power Cord Table:
The power cord set must be approved for the country where it is used.
WARNUNG Netzkabel Tabelle:
Das Netzkabel muss für das Land, in dem es verwendet wird, zugelassen werden.
警告：电源线表格：
电源线组件必须满足使用的国家认证要求。
U.S.A. and
Canada
•
The cord set must be UL approved and CSA certified
•
The minimum specification for the flexible cord is:
•
No. 18 AWG
•
Type SV / SVT or SJ / SJT or SPT-2
•
3 conductor.
•
The cord set must have a rated current carrying capacity of at least
10A.
•
The attachment plug must be an earth-grounding type with a NEMA
5-15P (15A, 125V) or NEMA 6-15P (15A, 250V) configuration
United Kingdom
•
The supply plug must comply with BS1363 (3-pin, 13A) and be fitted
with a 13A fuse that complies with BS1362
•
The mains cord must <HAR> or <BASEC> marked and be of type
H03VVF3G1.0 (minimum).
Europe
•
The supply plug must comply with CEE 7/7 (“SCHUKO”)
•
The mains cord must <HAR> or <BASEC> marked and be of type
H05VVF3G1.0 (minimum)
Denmark
•
The supply plug must comply with section 107-2-D1, standard
DK2-1a or DK2-5a.
Switzerland
•
The supply plug must comply with SEV/ASE 1011
中国
•
电源线组件必须通过
CCC
认证。
•
使用符合
GB1002
，额定值为
250V/10A
的单相两级带接地插头
•
电源线最小线径为
1.0mm
2
；当电源线长度小于
2m
时，电源线最小直
径为
0.75mm
2
The appliance coupler (the connector to the unit and not the connector to the wall plug) must have a
configuration for mating with an EN 60320 / IEC 320 C8 appliance inlet.
Die Gerätesteckvorrichtung (der Anschluss an die Anlage, nicht an den Wandstecker) muss mit
einer Konfiguration nach EN 60320 / IEC 320 C8 versehen.
Summary of Contents for WA4320H-ACN
