6
Figure 5 Marking installation holes on the wall
3.
Drill holes with a diameter of 5 mm (0.197 in) and a depth of 30 mm (1.18 in) in the marked
locations, as shown in
Figure 6 Drilling holes in the wall
4.
Insert a wall anchor into each hole, and tap the wall anchor with a rubber hammer until it is all
flush with the wall surface, as shown in
.
Figure 7 Hammering the anchor
73 mm (2.87 in)
69.4 mm (2.73 in)
69.4 mm (2.73 in)