20
Save or display diagnostic information (Y=save, N=display)? [Y/N]:y
Please input the file name(*.tar.gz)[flash:/diag_WX2540H_20170421-234326.tar.gz]:
Diagnostic information is outputting to flash:/diag_WX2540H_20170421-234326.tar.gz.
Please wait...
Save successfully.
To view the file content:
a.
Use the
tar extract
command to extract the file.
b.
Use the
gunzip
command to decompress the extracted file.
c.
Use the
more
command to view the content of the decompressed file.
•
Display the operational statistics for each feature module of the device. (Details not shown.)
<H3C> display diagnostic-information
===============================================
===============display clock===============
23:45:48 Beijing Fri 04/21/2017
Time Zone : Beijing add 08:00:00
=================================================
===============display version===============
H3C Comware Software, Version 7.1.064, Release 5323
Copyright (c) 2004-2017 New H3C Technologies Co., Ltd. All rights reserved.
H3C WX2540H uptime is 0 weeks, 0 days, 0 hours, 27 minutes
Last reboot reason : User soft reboot
…
Displaying detailed information about the device
Use the
display device verbose
command to display detailed information about the device.
<H3C> display device
Slot No. Subslot No. Board Type Status Max Ports
1 0 WX2540H Normal 6
Table 5
Command output
Field Description
Slot No.
Slot number.
Board Type
Card model.
Status
Operational status of the card:
•
Fault
—The card in the slot has failed and cannot boot correctly.
•
Normal
—The card in the slot is operating correctly.
Max Ports
Maximum number of interfaces that the card supports.
Displaying the electronic label data for the device
An electronic label is a profile of a device. It contains the permanent configuration, including the serial
number, manufacturing date, MAC address, and vendor name.
Use the
display device manuinfo
command to display the electronic label data for the device.
