Operation Manual – Call Services
H3C XE 200/2000 IP PBX
Chapter 23 Group Notification Service
23-2
However, after the deliverer hangs up, all receivers stop receiving the notification and
none of them can listen to it again by dialing the access code.
The remote group notification service allows an anonymous subscriber to be a member
of the notification group, but the anonymous subscriber has no ability to use the access
code to listen to the notification. The notification deliverer must not be an anonymous
subscriber.
To use the group notification service, you need to enable the MS on the XE IP PBX first.
Otherwise, the service will be unavailable and the deliverer will hear the busy tone after
picking up the phone and dialing the access code.
23.1.2 Using Group Notification Service
I. Use local group notification service
1) Store the media file pre-recorded for the group notification service into the Flash
memory of the XE IP PBX.
2)
Configure media ID for the file. Refer to the “Configuring a Media Resource” part in
the
Media Server Operation
module for details.
3)
Configure the receiver group. Refer to
Configuring Notification Receiver Group
for
details.
4)
Set the local group notification parameters, including specifying the media file ID,
notification time, receiver group, access code and notification retry interval. Then
activate this notification.
5)
When the notification time comes, the phone sets of all members in the specified
group ring.
6)
The subscribers pick up the phones and listens to the notification.
7) If a subscriber does not picks up the phone, the phone rings again after the
predefined interval, so that the subscriber can pick up the phone and receive the
notification. The phone rings up to 10 times if it is not picked up.
8)
If a subscriber hangs up when listening to the notification, the XE IP PBX will not
send invitation to that subscriber again because it considers the subscriber has
completed receiving the notification.
9)
After the notification is completed, subscribers can listen to it again by dialing the
access code the administrator designated for the notification.
II. Use remote group notification service
1)
Configure the receiver group. Refer to
Configuring Notification Receiver Group
for
details.
2) Set the remote group notification parameters, including specifying the receiver
group, access code and notification sending interval. Then start this notification
task. Refer to
Configuring Remote Group Notification
for details.
Summary of Contents for XE 200/2000 IP
