15
DEUTSCH
ENGLISH
FRANÇAIS
ITALIANO
ESPAÑOL
NEDERLANDS
PORTUGUÊS
SVENSKA
DEUTSCH
ENGLISH
FRANÇAIS
ITALIANO
ESPAÑOL
NEDERLANDS
PORTUGUÊS
SVENSKA
© HAAG-STREIT AG, 3098 Koeniz, Switzerland - HS-Doc. no. 1500.7220589-04170 – 2016 – 02
F.4 Immunity for non-life support devices (standard table 4)
Guidance and manufacturer's declaration – electromagnetic immunity
This product is intended for use in the electromagnetic environment specifi ed below. The customer or the user of this product should assure that it is used in such an envi-
ronment.
Electromagnetic environment – guidance
Portable and mobile RF communications equipments hould be used no closer to any part of this product, including cables, than the recommended separation distance cal-
culated from the equation applicable to the frequency of the transmitter.
Immunity test standard
EN 60601 test level
Compliance level
Recommended distance
(c)
:
Conducted RF EN 61000-4-6
3 V
rms
150 kHz – 80 MHz
10 V
rms
D = 1.2
Radiated RF EN 61000-4-3
3 V/m
80 MHz – 2.5 GHz
10 V/m
80 MHz – 2.7 GHz
D = 1.2 80 MHz – 800 MHz
D = 2.3 800 MHz – 2.5 GHz
Where P is the maximum output power rating of thet ransmitter in watts (W) according to the transmitter manufacturer and D is the recommended separation
distance in metres (m). Field strengths from fi xed RF transmitters, as determined by an electromagnetic site survey
a
, should be less than the compliance level
in each frequency range
b
Interference may occur in the vicinity of equipment marked with the following symbol:
NOTE 1: At 80 MHz and 800 MHz the higher frequency applies.
NOTE 2: These guidelines may not apply in all situations. Electromagnetic propagation is affected by absorption and reflection from structures, objects and people.
a. Field strengths from fi xed transmitters, such as base stations for radio (cellular/cordless) telephones and land mobile radios, amateur radio, AM and FM radio broad-
cast and TV broadcast cannot be predicted theoretically with accuracy. To assess the electromagnetic environment due to fi xed RF transmitters, an electromagnetic
site survey should be considered. If the measured fi eld strength in the location in which this product is used exceeds the applicable RF compliance level above, this
product should be observed to verify normal operation. If abnormal performance is observed, additional measures may be necessary, such as re-orienting or relocating
this product.
b.
c.
Over the frequency range 150 kHz to 80 MHz,
Possible shorter distances outside the ISM bands do not contribute to improved application in this table.
fi eld strengths should be less than 3 V/m.
01-IFU_BQ900-7220589-04180_eng.indd 15
20.01.2016 14:52:25
