STEP 20
If the alignment is correct, torque the (10) screws that attach the wedge to
the ballscrew nut housing.
For torque values, refer to
Haas Fastener Torque Specifications
.
STEP 21
For machines with a Y Axis, you must align the wedge [1], after you align
the saddle [2], as shown in the previous section.
STEP 22
For machines with a Y Axis, the steps to align the X Axis are the same as
the previous steps.
Loosen the (16) screws that attach the wedge to the linear guide trucks
and the (8) screws that attach the wedge to the ballscrew nut housing.
The only difference is that the (8) screws that attach the wedge to the
ballscrew nut housing are in the rear, as shown [1].
Copyright 2018 by Haas Automation, Inc. No unauthorized reproduction | Last Published On November 05, 2015
30/67
