STEP 11
When the alignment is correct, tighten to approximately half of the
specified torque the (4) screws that attach the turret housing casting [1] to
the riser [2].
For torque values, refer to
Haas Fastener Torque Specifications
.
STEP 12
Measure the alignment.
STEP 13
If the alignment is correct, torque the (4) screws. For torque values, refer
to
Haas Fastener Torque Specifications
.
ST, DS - Toolholders to the Spindle Centerline - Correction
This section tells you how to align the toolholders [1] to the spindle centerline [2].
Copyright 2018 by Haas Automation, Inc. No unauthorized reproduction | Last Published On November 05, 2015
35/67
