Haas Door 610, Operation & Maintenance Manual

Haas Door Commercial Instruction Manual

8  

          © 2015 Haas Door Company  

           Rev. 7/15

STEP 19 CYLINDER LOCK INSTALLATION

If lock cylinder is supplied, install in lock section as shown in the exploded view (see Figure 22).

STEP #20 LIFT HANDLES

Install lift handle(s) on bottom section with 1/4” - 20 nuts and 
bolts supplied (as shown in fig. # 23).

MAINTENANCE & CAUTIONS

Recommended Service: lubricate rollers with a light oil as required. Check and tighten all nuts, bolts and screws annually. 
(This may be required more frequently for high usage doors.) 
 
Haas Door recommends servicing any part of the counterbalance system including springs, drums cables, bearing brackets, 
and bottom corner brackets where cable is attached be performed by qualified door service personnel only (see notice below). 

Important Safety Notice: 

Operate door only when properly adjusted and free of obstructions. Door is under extreme spring 

tension. Repairs and adjustments, especially to cables and spring assembly, can be hazardous and should be performed by 
qualifled door service personnel only.
Do not permit children to play with garage door or electric controls.
If door is now, or later becomes, electrically operated, pull down rope must be removed.
Avoid standing in open doorway or walking thru doorway while electrically operated door is moving.
Should door become hard to operate or completely inoperative, it is recommended that a qualified door agency be contacted.
The notice above has been approved and recommended by the National Association of Garage Door Manufacturers (NAGDM).