Page 13
Shortly thereafter, a NEW Location Report will appear. Receipt of an accurate Location Report will
verify that the Text-N-Track H1000 unit is operating properly and is ready to be delivered to the customer.
Congratulations! You’ve completed the physical installation, the registration, and final test. You are now
ready to deliver the system to your customer.
Note: If you submitted any personal information – such as your own cell phone number –
during the registration process, please remember to remove it before delivering the system to
your customer.
B. Using a cell phone to test the Text-N-Track H1000
Note: Instructions for creating and sending text messages from cell phones are beyond the
scope of this document. This guide assumes that reader is already familiar with text
messaging. This guide provides the necessary information to enable a reader with text-
messaging skills to send commands to a remote monitoring unit and to receive reports from it.
If you are already familiar with text-messaging, you can also use a text-enabled cell phone to test the
Text-N-Track H1000. The test will consist of using a cell phone to send a “Locate Now” command to
the remote Text-N-Track H1000 unit, and receiving a response from it on a cell phone. Here’s how
you can use a cell phone to perform the final test:
-
Configuration: During the online registration process, you must use the Configuration Page to
specify the cell phone for sending and receiving messages. After the cell phone has been
specified on the Configuration Page, you can use it to send a “Locate Now” command to the
Text-N-Track H1000 unit.
-
Message Format: The format for the “Locate Now” command consists of the password,
followed by a single blank space, followed by the digit 1.
o
The password was previously specified on the Configuration Page. For new customers,
the password is always set to 1234
o
A single blank space should separate the password from the command
o
The command for “Locate Now” is the digit 1.
The message format for a new customer sending a “Locate Now” command message from a
cell phone is therefore as follows: 1234 1 (NOTE: There is a space between password and
command)
-
Phone Number: The text message should be directed to the Text-N-Track H1000 unit’s
Mobile Identification Number (this is its 10-digit “phone number”).
Using a text-enabled cell phone, send the “Locate Now” command to the Text-N-Track H1000 unit.
Again, the message should consist of the following: 1234 1
