3
2. When using the fire protection insulating set, mount the two rear wall screen panels (see
installation instructions of the fire protection insulating set) to the rear wall of the fireplace.
3. Adjust the fireplace to the correct height using the open-end wrench size 13mm by turning the
adjustable feet. The ideal height is shown in Figure 2. For comparison, install the base with the
base plate. The lower edge of the panel with air damper on the fireplace can end flush with the
sub-structure of the concrete lining or be approximately 1 to 2 mm higher (Attention: The
gluing will result in a minimal change of the overall height: however it is possible to
subsequently adjust the correct height by turning the adjustable feet).
4. In addition to this the distance to the screen wall must be adjusted to the correct dimension (see
Figure 2).
Important:
After this, adjust the fireplace horizontally using the water level.
5. Locate the flue pipe connection (e.g. with double wall lining) in the chimney (see installation
and operating instructions of the fireplace).
6.
Now start installing the kit.
6
INSTRUCTIONS
It is not permissible to install the kit by gluing the elements together without protecting the fireplace
hood against slipping!
Following the installation, place the refractory lining in the fire chamber of your fireplace (see
equipment sheet of your fireplace). Why refractories last? Because the fireplace can be easier
repositioned while assembling the artificial stone kit.
To avoid minor joints between the kit and the wall we recommend to grout these with acrylic
compound (in contrast with silicon, acrylic can be painted over immediately).
Once the fireplace kit has dried, the fireplace can be painted (mineral-based paint, no depth primer
required). In order to achieve a fine-grain structure, simply mix some adhesive into the paint for
the first coat. Use only paint for the second coat. Of course roll-on or rub-on plasters can also be
used to finish the surface.
Allow the fireplace kit to dry for at least two weeks before initial start-up.
To start the fireplace: Carefully read the operating instructions and start the fireplace using little
wood. After approximately one hour the device can be heated to rated heat.
