GB
23
11. Oper. modes
11.1. Burner test before start zone
The start zone begins if:
• the current room temperature falls below the set target temperature by 1 °C
• the stove is cooled down to a temperature below 70 °C
A burner test is performed before each start zone. After a successful burner test the start zone is initiated.
11.2. Start zone 1-30 (start zone)
The whole "start zone" can go through up to 30 zones. It finishes after reaching a precisely defined
temperature at the "flame temperature sensor" and the control system puts the stove into "Heating mode".
The duration of the "start zone" can therefore vary.
If, during the start zone, no flame generation can be achieved or the required temperature at the "flame
temperature sensor" cannot be reached, a shut down process is initiated.
11.3. Heating mode
After the positive conclusion of the
"start zone"
, the stove automatically switches to
"Heating mode"
.
Manual control
: The heat output of the stove is regulated in 5 preset levels. The higher the level (1-5), the
higher the heat output.
Automatic control
: The heat output is controlled according to the difference between the set and Actual room
temperature.
11.4. Burner test (when heating)
During the
"Heating mode"
operating state, the burner test is started in cycles depending on the selected
heat output level. The burner test takes approx. 3 min.
11.5. Cooling down
If the set Setpoint temperature is reached or the "ON/OFF" button is pressed, then the operating status
switches to "cooling down". The cooling down phase is restricted by timing control (duration about 15
minutes). After the end of the "Cooling down" operating status, the appliance switches to "standby" operating
status or "OFF".
11.6. ECO-Mode
If the ECO-Mode mode is activated, the stove will not turn off when the "Setpoint temperature" is reached. The
stove continues to burn with a "smaller flame". If the "Setpoint temperature" is exceeded by more than 3 °C,
then:
• the stove enters the "Cooling down" operating mode
• if the "Actual room temperature" exceeds 30 °C in the ECO-Mode operating mode, the stove enters the
"Cooling down" operating mode.
The ECO-Mode remains active in both cases.
