GB
10
• Remove any stickers.
• Remove all accessories from the pellet tank and the combustion chamber.
• Check whether the combustion chamber cladding (see appliance sheet) is attached to its fastenings. This
could have slipped out of its position as a result of the transportation or installation of the stove.
• Check that the burner fits perfectly in its mounting.
• Close the combustion chamber door.
• Fill the storage container with pellets.
• Plug in mains cable.
CAUTION
To eliminate the risk of fire, only refill pellets to the tank when the stove is not heating.
When refilling pellets to the tank, make sure that the pellets do not fall outside the tank, e.g. into the holes in
the stove lid.
Note
For type
HSP 4.0-F2
: when using for the first time, the Manual filling process must be started twice. (see point
9.1.12)
Due to the different expansion of the materials used, the stove may make sounds resembling
ticking or
banging
when heated or cooled.
In principle, these sounds cannot be eliminated during operation. Due to the different expansion of the
materials used and the sounds from the motor, fan, etc., sound effects with low noise levels may occur.
These sounds are due to factors that are out of control and therefore should not be considered a reason for
claims.
7.3.2. Operating console:
As soon as the mains plug is connected, the software version ap-
pears on the display for approx. 4 seconds
Touch display.
7.3.2.1. Language selection
Language
After that you can select your required language.
Procedure:
The required language is selected with the
or
buttons
and confirmed with
"OK"
.
Deutsch
Español
Englisch
Franҫais
Summary of Contents for HSP 4.0-F2
