STEP 2
Release
[EMERGENCY STOP]
.
To make sure the travel limits of the A axis are correct
[HANDLE JOG]
in
the positive and the negative direction. Make sure the movement stops at
120 degrees in each direction.
Caution:
Stop jogging the axis if the A axis (tilt) moves more
than 120 degrees. Make sure that Setting
30 4TH AXIS ENABLE
and Setting
78 5TH AXIS ENABLE
are correct. If the settings are
correct and the A axis (tilt) still moves more than 120 degrees,
speak to your Haas Factory Outlet (HFO).
Rotary - TR/TRT/T5C - Alignment
This procedure tells you how to align a multi-axis trunnion to the table. The platter or the collet face must be parallel to the X-
axis movement. The error cannot be more than 0.0003" (0.008 mm).
STEP 1
Tilt the A axis to 90 degrees.
Put the magnetic base of a dial indicator [1] on the spindle head.
Jog the X axis to center the platter [2] on the spindle. Jog the Y and Z
axis until the indicator is in front of the platter, near the edge. Make sure
you can indicate the full diameter from left to right.
Set the indicator to zero.
Indicate the platter or collet face along the X Axis. If the error is more than
0.0003" (0.008mm) use a rubber or plastic mallet to adjust the position of
the rotary. On the side near the front doors, adjust the rotary by lightly
tapping on the rotary base. Watch the indicator while making adjustments.
Repeat this step until the error is less than 0.0003" (0.008mm).
If the error is within range tighten all of the screws. Indicate along the X
axis to make sure the rotary did not move. If the error is more than
0.0003" (0.008mm) lossen the screws. Adjust the position of the rotary.
Watch the indicator while making adjustments. Repeat this step until the
error is less than 0.0003" (0.008mm).
If the error is within range the installation is complete.
Rotary - TR/TRT/T5C - Lifting Instructions
Lift the rotary table with the lift rings as shown to prevent damage to the gear set. Attach an air supply to the rotary before you
lift it. All rotary tables (HRT's, TR's TRT's and T5C's) use the 1/2-13 eyebolts. Haas Automation, Inc. does not supply lifting
chains or straps for rotary products.
Copyright 2020 by Haas Automation, Inc. No unauthorized reproduction | Last Published On December 13, 2016
10/12
