Symptom Table
SYMPTOM
POSSIBLE CAUSE
CORRECTIVE ACTION
The wipers are worn or
damaged.
Normal wear on wipers.
Replace the wipers.
A part or other heavy object dropped
on the way cover.
Remove the dents from the way cover.
Cutting abrasive or absorbent
materials.
The way covers are not lubricated
correctly.
Extra protection is necessary when you cut abrasive
or absorbent materials.
The way covers are
damaged or worn.
Chip build-up around the base of roll
shade way covers.
Clear debris from the base of the covers and adjust
the tension on the spring-loaded canisters.
Way covers "pop," or do
not move evenly.
Normal operation.
These symptoms are normal during operation and do
not require troubleshooting.
Way cover has trouble
extendening or retracting.
Way cover is full of chips.
Perform normal machine maintenance.
There is a low coolant concentration.
Increase the coolant concentration.
Way cover movement during dry
machine operation creates friction.
Lube the way covers with oil.
The way covers are rusty or
make excessive noise.
The rail screws are loose.
Tighten the loose rail screws.
The Wipers are Worn or Damaged
Symptom:
The wipers are worn or damaged.
Possible Cause:
Normal wear on wipers.
Corrective Action:
Replace the damaged wipers where possible.
Replace the damaged wipers on telescopic way
covers with the correct kit for your machine. Go
to
PARTS.HAASCNC.COM
.
Way Cover - How it Works and Troubleshooting Guide
Page 2 of 7 pages
