Operating instructions 4123
Flexproof-Cutter
AF-61/8x30
Page
3
of
14
Edition: 01/0206
Subject to alterations
1. General
information
1.1 Application
The Flexproof-Cutter AF-61/8x30 was specifically designed for the rapid and safe preparation (die-cutting) of
Habasit spindle tapes and Hamid machine tapes using the Flexproof procedure. The belts/tapes can be up
to 60 mm/
2.36 in.
width and 3 mm/
0.12 in.
thickness. It is suitable for Habasit standard finger geometry with
the pitch of 8 x 30 mm. Die-cutting is done in manual strokes‚ resulting in the most precise finger cut and
therefore optimum joint strength.
The Flexproof-Cutter AF-61/8x30 was developed solely for the purposes described in the operating
instructions. Improper use, or use for other applications than those described in the instructions, is not
permissible. Habasit accepts no liability for the consequences of improper application.
The AF-61/8x30 is manufactured according to the state-of-the-art and fulfills the EC safety regulations.
These operating instructions imply that all assembly, maintenance, and repair work, as well as operation of
the die-cutting device, be carried out by skilled personnel or monitored by responsible specialists.
For reasons of scope, these instructions cannot cover all possible aspects of operation, maintenance, or
repair. The indications given herein refer to the use of the tools according to their designated purpose by
skilled personnel.
In case of doubt or if further detailed information is required, please contact the manufacturer (Section 1.4)
1.2
Important safety terms
In these operating instructions, you will find the terms WARNING, CAUTION, and INDICATION. They signal
dangers or special information to be borne in mind.
WARNING
If disregarded, there is a danger of severe injury, and/or severe material damage.
CAUTION
If disregarded, there is a danger of injury, and/or material damage may be caused.
INDICATION
Technical information is emphasized if it is important and not readily apparent, even for
skilled personnel.
Please observe all indications for assembling, operating, and maintaining this device, as well as all technical
data! This will prevent possible trouble and/or damage to people or materials.
Skilled personnel
refers to persons authorized to perform the required work. These people have been
sufficiently trained and introduced to their field of activity so that they are able to recognize and prevent
dangers. They are aware of the pertinent provisions and safety regulations.
4123INS.FAB-en0306ITA
